Random good picture Not show

181 Pulsed corona discharge plasma was used to treat ethanethiol in the air. The influences of gas flow rate (or residence time) and moisture of gas flow on removal efficiency were investigated.

182 Self-purification curves are presented, percentages and rate constants of the purification are calculated, and influence of temperature, flow rate, and turbidity on self-purification are discussed.

183 The best oil-saving effect is gained by detetruing the optimized values of magnetic density, flow rate of oil through the magnetizer, and magnetizing time.

184 The primary outcome was the morning peak expiratory flow rate.

185 A dynamic chamber technique was employed to investigate the effects of formaldehyde concentration, light intensity and flow rate on formaldehyde purification from air by potted spider plant.

186 Higher heat transfer rate as air mass flow rate increases.

187 Four events could result in a decrease of core coolant flow rate.

188 The main technical parameters (such as sample flow rate,(http://sentencedict.com/flow rate.html) sample time and noise level and so on) are tested and compared with the prototype made in foreign countries.

189 Either flow rate is insufficient or CPU is over occupied.

190 The diameters and flow volume as well as blood flow rate of splenic vein and superior mesenteric vein were markedly higher in cirrhosis with hemorrhage than those without hemorrhage.

191 And the result of the pilot study shows that vacuum pressure, ratio of liquid and gaseous flow rate, flow sheet and packing density of the membrane module also have the significant influence.

192 Therefore, outlet air temperature tends to decrease as air mass flow rate increases.

193 Then, HCl solution was used as a regenerant for modified zeolite. Influence that concentration of HCl, flow rate and regenerating time on regeneration effect was also studied.

194 As a result, the removal efficiency decreased obviously with increasing gas flow rate, because both the residence time of ethanethiol in plasma reactor and energy density decreased.

195 The formation of MCB and PAHs could be largely reduced by increasing the air flow rate.

196 The mass flow rate varies with the inner diameter and the length of adiabatic capillary tubes, the degree of subcooling and the condensing temperature were investigated.

197 You can convert this value easily to the equilibration time by dividing by the flow rate in milliliters per minute.

198 Researches the interaction of the multiple equal plumes based on the principle of momentum congruence. Defines three velocity correction coefficients and a flow rate correction coefficient.

199 It also discusses the location and installation of Pitot tube and introduces the way to determine the average flow rate from the central flow rate inside a pipe measured by the Pitot tube.

200 By measuring the cooling curve and quench severity of quenching oil at various flow rates, the relationship among the hardening capacity[sentencedict.com], quench severity and flow rate was established.

201 Thus the gas flow rate, nozzle inner and outer diameter are important influential factors on bubble size.

202 Total phosphatidylcholine was isolated from soybean lipids with ethanol water. The effect of composition and flow rate of mobile phase was investigated.

203 A high flow rate and pressure of hydrogen was in favor of the catalytic reduction of nitrate, but not benefit for the selectivity.

204 Demolition material are the advantages of pipe cleaner pipe cleaning, water flow rate can be relatively low, may be suspended.

205 The maximum potential of energy saving for variable frequency regulating is 0.385 when the ratio between the actual volume flow rate and design volume flow rate is 0.577.

206 The water model experiments show that the circulation flow rate with swirling flow increases significantly.

207 The results showed that high quality fiber Z30S was obtained including low ash content, high isotacticity and good stability of melt flow rate.

208 The tube is graduated so that flow rate can be read directly on a linear scale.

209 The network inputs include extruder temperature, die temperature , melt flow rate, air flow rate, die to-collector distance.

210 Dynamical, i. e. load-adaptive strategies may have an important effect on the flow rate and result in a better system behaviour than statical strategies.